Wissem - Développeur AUTOMATE

2018 - Present Electrical Test Engineer & Commissioning STEG
Specialization of parameter setting & commissioning of electrical protection relays
 Project protection relay settings (DIGSI 5 (SIEMENS), DIGSI 4 (SIEMENS), PCM600 (ABB), MICOM S1 Agile) with Test boxes mastered (OMICRON CMC 356 and OMICRON CPC 100).
 Protection relay Tests FAT & SAT.
 Electrical network modeling
 Calculation of transmission line parameters
 Functional Tests of GIS.
 Pre-commissioning & Commissioning.
 Checking of polarities.
 Test of current & potential transformer (primary & secondary injection).
 Test of interlocking.
 Checking of local & protection Panels.
 Forwarding information toward CCN & Dispatching.

2015 - 2017 Automation & Control Engineer
Integration Objects
Specify, design configure and test Distributed Control System (DCS) and Supervisory Control and Data Acquisition System (SCADA).
 Instrumentation design and interfaces to PLC/RTUs such as Emerson, HIMA, Rockwell and GE.
 Configuring industrial networks (Modbus, OPC and DNP3).
 Design and commissioned electrical cabinets.
 Low voltage devices, protection remote control systems and data treatment.
 Technical position for implementing full automation projects including electrical. safety, automation, instrumentation, IT, and networks solution.
 Engineered, configured a telemetry solution for an Oil and Gas field with Emerson Bristol Babcock and Controlwave RTUs.
 Engineered, configured and commissioned an ESD-F&G system HIMA Hiquad H51q-HS for an Oil and Gas Platform.
 Programmed and tested HIMA HIMatrix F35 for ESD and F&G systems for an Oil and Gas plant.
 Designed and Implemented Emerson DeltaV system for Oil and Gas plant.
 Designed, Implemented and Commissioned ControlLogix Rockwell System for an Oil and Gas plant.
 Programmed, tested and implemented Factory Talk View Rockwell SCADA software for an Oil and Gas plant.
 Programmed and tested GE PAC8000 RTUs for an Oil and Gas plant.
 Programmed and tested GE SCADA CIMPLICITY for an Oil and Gas plant.
 Engineering documents preparation: Architecture diagram, Network diagram. Electrical cabinet panel Layout, Server cabinet layout, Power Conception and Heat Dissipation calculation, Control logic diagram, Internal Acceptance Test, Factory Acceptance Test and Site Acceptance Test procedure documents.
 IT material configuration: Server cabinet material installation, Server platform preparation, RAID configuration.

2014- 2014
Automation Trainee
KBE Elektrotechnik
Automation of a dosage unit.

2013- 2013
Automation Trainee
SAGEMCOM
Simulation of supply chain
Student
INSAT
Design and implementation of smart house using STM32
Performing Ball & Beam system via LabView
Design and implementation of a robot “Ovoider of obstacles” and participating in the national competition Robocomp

Training
2010 - 2019
CPC 100, Omicron
DeltaV course 7009, DeltaV Implementation
DeltaV course 7018, DeltaV Hardware & Troubleshooting
DeltaV course 7305, DeltaV SIS Implementation
PCSD v13a Overview « Implementation of Emerson PCSD v13a DeltaV Library »
SP101 SIS course « Introduction to Safety Management System and to IEC61508 and
IEC61511 standards »